MitsuStyle
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

MitsuStyle (http://www.mitsustyle.com/forums/index.php)
-   Good Guy / Bad Guy feedback (http://www.mitsustyle.com/forums/forumdisplay.php?f=81)
-   -   Beware! 1G4g63t (http://www.mitsustyle.com/forums/showthread.php?t=29912)

niterydr 07-27-2011 10:39 AM
Re: Beware! 1G4g63t
 
Quote:
Originally Posted by 1QUICK4 (Post 388889)
Maybe a spun balance shaft bearing?
Hope not as that could cause death to the oiling system. Did you ever see those with your time at Mitsu? Of all the 4g's I've ripped apart, never seen a spun balance bearing, I've seen cooked ones though!

Super Bleeder!! 07-27-2011 10:41 AM
Re: Beware! 1G4g63t
 
Maybe the sound is timing belt slap? I think my engine makes some noise around that rpm range as well, been that way for years.

2slow4now 07-27-2011 11:25 AM
Re: Beware! 1G4g63t
 
Quote:
Originally Posted by niterydr (Post 388918)
Hope not as that could cause death to the oiling system. Did you ever see those with your time at Mitsu? Of all the 4g's I've ripped apart, never seen a spun balance bearing, I've seen cooked ones though!
I have seen a 1g with a spun bearing. It was on the oil pump drive side. It made alot of noise and after a clean up and a balance shaft delete it was fine. I just used the short shaft for the pump drive.

93gtpeater 07-27-2011 11:33 AM
Re: Beware! 1G4g63t
 
I have had the balancer shaft bearing fall out and it would make a rattle noise at 2500 rpms.


All times are GMT -5. The time now is 07:55 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.