Re: Bent valves? or Droped a valve, Pictures inside!
 

stock head bolts and the factory organic gasket will do you just fine.

Re: Bent valves? or Droped a valve, Pictures inside!
 

Aren't new headbolts kinda pricey?

Re: Bent valves? or Droped a valve, Pictures inside!
 

I didn't think they were torque to yield bolts? I would reuse them on a mild setup.

Re: Bent valves? or Droped a valve, Pictures inside!
 

The 6 bolt head bolts are not TTY, so if the threads look good put some oil on the threads and under the bolt head and fallow the factory torque down method. Or a set of ARP head studs is around $100 new. If you go the ARP route I recommend torquing them to 100ft/lbs with the moly lube. And if you use a composite gasket to put copper spray on it.

~John

Re: Bent valves? or Droped a valve, Pictures inside!
 

Yea i had a 6 bolt lined up but that fell through, so a Yeai'm a go mls and get some arps and post some pics of my little rebuild in the project fourm.