Re: GsXtUrBo98's 2G project thread
 

Yes just down the road from there.

Re: GsXtUrBo98's 2G project thread
 

Got the axle in and changed the oil. Also, I ordered my cdi ignition box from map and should be in on Monday

Re: GsXtUrBo98's 2G project thread
 

Went and picked up my dyna tec cdi today from map but did not install.. Went to the gas station to fill her up and she runs great with the fresh gas but the rear end still clunks even after replacing the 2 rear axles with hd ones..... I guess it could be the rear diff itself..

Re: GsXtUrBo98's 2G project thread
 

Does it clunk when shifting? If so, it's probably the rear diff bushings. Evo's do the same crap. Doing new rear diff bushings and driveshaft bushings cures it most the time.

Re: GsXtUrBo98's 2G project thread
 

No, its only when I'm making a sharper turn.

Re: GsXtUrBo98's 2G project thread
 

Does it clunk driving strait, turning, or both?

Re: GsXtUrBo98's 2G project thread
 

Turning

Re: GsXtUrBo98's 2G project thread
 

Do you have a welded center diff?

Re: GsXtUrBo98's 2G project thread
 

He does

Re: GsXtUrBo98's 2G project thread
 

Are you sure that isn't the noise you are hearing?

Re: GsXtUrBo98's 2G project thread
 

That is def from having a welded center diff. Happens to all with a welded diff if you are turning in tighter areas.

Re: GsXtUrBo98's 2G project thread
 

So I installed a dynatek arc2 and am still having break up problems.. I was at 27psi and turned it down to 25psi and it wasn't as bad. But then I turned it down to 22psi and she goes pretty damn smooth through the gears.. I think I'm in need of a retune..

Note: I also fixed some boost leaks but there isn't any difference from before or after since they were before the maf

Re: GsXtUrBo98's 2G project thread
 

What are your plugs gapped at?

Re: GsXtUrBo98's 2G project thread
 

20

Re: GsXtUrBo98's 2G project thread
 

what plugs?

Re: GsXtUrBo98's 2G project thread
 

Ngk bpr8es

Re: GsXtUrBo98's 2G project thread
 

If they're more than a couple months old, I'd try new plugs first.

Re: GsXtUrBo98's 2G project thread
 

Why are you running those plugs may i ask?

Switch to BR7ES and see if that changes. If you are on E85 those may be too cold.

Re: GsXtUrBo98's 2G project thread
 

The plugs are brand new just installed. Brad ran them in his 2g so I through them in last year and hadno problems..

Re: GsXtUrBo98's 2G project thread
 

hmm, i guess I'd try the BR7ES and see if they help any, cheap enough to try.