ARP Moly Lube - where to buy

[Halon]

Sorry to bring this back from the dead, but I need some sort of lube for 1 head stud. When I took the head off, one of the head bolts came entirely out, not the nut, te entire stud. So I need to put it back in but don't have any ARP lube around, so what can I use, and where can I get it? Thanks

[Pimpin Dsmstyle]

I might have some laying around. I'll check sometime when i have time.

[blageo23]

I have a big ol bottle of the stuff(when I ordered it I didnt know it was that big) If you stop by my house after 12 tomorrow I can let you use some.

[Halon]

Well I work in Shoreview, so maybe after work I could stop by and snag some. I work right off Hwy 96 and Lexington.

[blageo23]

Where do you work at? I live northeast of there. By County Road J and 49. Give me a call If you want to stop by. Cell- 651-492-5547

[slowbubblecar]

You are going to use it on the side that goes into the block? I am pretty sure you aren't supposed to use it on that side. I thought the directions said to only use it on the side where the nut is and to clean the holes in the block out so there is no oil in there.

[Shane@DBPerformance]

Yea, the ARP Moly Lube goes on the washer, nut and threaded stud end that the nut goes on to. You don't put lube on the side that goes into the block. If anything, you would put loctite on the threads going into the block, but that isn't necessary.

[niterydr]

Studs go in the block dry, with dry holes.
ARP lube on the washer, bottom of nut, and the stud that sticks out.

[Halon]

OK well I'm a dumbass then, i had put it on both sides before. But either way I guess I still need some for the nut side. I'll give you a call when I'm on my way out of work. I work at PaR Systems, right off Hwy96 and Lexington, and I get off at 3:30

[iceminion]

Ok, from the ARP website, its ok to use oil in place of moly lube, you just need to tighten it differently....

I have a head that I need to bolt up to a block for a while and I have arp headstuds

unfortunately the washers are no where to be found? can I get some hard washers from ace? (same footprint as the nut)

and what is the foot poundage that I have to tighten them to? with 30w oil?