Al Blaha 1G mass modification?

[x-pride]

Does anyone know how to do this mod? I heard about a resitor and hacking the MAS but that is it. I have tried searching the web but could not how to exactly do this mod. Any help will be greatly appriciated.

[Shane@DBPerformance]

What do you have to tune with? What size is your turbo? And what size are your injectors? There are a few ways to do an "Al Blaha" style MAS, and it helps to know exactly what you are working with or towards.

[sleepydsm]

Or you could get rid of the factory 1G MAS, and either wire in a 2g, get a GM maf, or go to a speed density system.

[Goat Blower]

Chuck your MAS and throw the AIT and airflow sensor in a one-gallon coffee can with the bottom cut out. Run some 4" dryer ducting from that to the turbo and seal it all up with duct tape, you're good to go.

[x-pride]

Shae: The car is running a PTE 56 trim turbo, 780 injectors and SAFC.

Steve your idea sounds intresting. How do I go upon finding info out on that modifictaion?

[PSI2HI]

Shae: The car is running a PTE 56 trim turbo, 780 injectors and SAFC.

Steve your idea sounds intresting. How do I go upon finding info out on that modifictaion?

If you plan to use that turbo to potential the 1G and even 2G MAS are not for you.

[x-pride]

If you plan to use that turbo to potential the 1G and even 2G MAS are not for you.
What would your recommend?

[acidrumz]

standalone or gm trans

What would your recommend?

[CVD]

You can always go to a HKS VPC ;)

[Kracka]

A Blaha MAS flows slightly more than a 2G MAS and roughly the same as a 3" GM MAF in draw-through setup. I ran a Blaha for many years and it was very easy to tune with.