RPM/Tach/Shift light problems, help!

[Swifty1638]

Ok, now I am facing wiring isues, who knew.

I have the green wire for my light attached to the black wire (pin 21 on back of large plug). The ground is behind the driver's side kick panel, and the power I ran off of the blue/white wire from the cigarette lighter. Yet, the light doesn't work at all. Any ideas?

-A. Swift

[turbotalon1g]

Really? strange, hmm, did u check the fuse for the cigarette lighter? Recheck connections, then i don't know. kinda hard on the net. Good luck, hopefully its the fuse.

[Swifty1638]

i'm missing the fuse cover for the ick panel thingy, so i really don't know what fuze it could be.

-A. Swift

[Swifty1638]

all the fuses down by that panel look good. I can turn the key to on, and the light will flicker, but it won't turn on when it hit's the pre-set rpm (3k for now). I re-did the wire running to the pin 21 on the ecu, with a better connector, but still, nothing. power is still connected to that cigarette lighter wire (blue/white) and the ground is still off that bolt behind the driver's lower kick panel.

-A. Swift

[scheides]

Double check your ground and quit using crap connectors; solder my friend, solder!

[Swifty1638]

Actually, i figured out the issue last night. The company who made the light didn't put the sticker you adjust the rpm to correctly on it, so 3k actually means like 5.5k. Whatever, I guess you can't expect too much from some company like that. I'll just do a rev-adjust session someday.

-A. Swift