PDA

View Full Version : Oil filter housing issue


Pimpin Dsmstyle
10-06-2005, 09:20 PM
92 talon TSI AWD. I haven't had much time to actually figure it out myself, as I think this is a pretty simple problem to fix. However, the problem is as follows.

~ On the internally cooled oil filter housing, there is a *water line* ( I think ) That points away from the housing and towards the motor. It is open and everything is hooked back up. I'm not sure what it does when it runs because I haven't seen it yet. The engine was out of the car for like 2 months so we do not remember what leads to there.

I've only put motors back into 90's so I'm not very used to the differences between to two "models". I know a 90 is externally oil cooled, and I'm pretty sure that line is not there. Which leads me to my next point to why I think it's a water line. 1990 oil filter housings are cooled externally by air / cooler. 91-94 must be internally cooled since the oil has to be cooled down. I would think this line should run to the main water pipe somewhere.

Any information / help would be greatly appreciated. Thank you very much!

niterydr
10-06-2005, 10:43 PM
its water cooled. It should accept a 3/8" coolant hose.

Pimpin Dsmstyle
10-06-2005, 11:11 PM
its water cooled. It should accept a 3/8" coolant hose.
but where does that hose go ;)

Matt D.
10-07-2005, 08:29 AM
but where does that hose go ;)
One connects to the nipple on the water pipe in the front of the engine, the other... :confused: