TurboDomestics
07-16-2005, 05:12 PM
I have everything out, and ready to get pulled except the shift linkage, Speedo cable and the mounts.
I cant figure out how to disconnect the shift linkage from the shifter base to get it through the fiirewall, how do I do this?
And also How do I dissconnect the Speedo cable from the transmission?
And last question is, where do I connect the engine hoist to pull the motor out? I found out where to connect it on the pass side, right by the VC, but I dont know where to connect it on the drivers side.
Also the drive shafts just fall out when I pull the tranny up? right?
thanks soooooo much
-Charlie
I cant figure out how to disconnect the shift linkage from the shifter base to get it through the fiirewall, how do I do this?
And also How do I dissconnect the Speedo cable from the transmission?
And last question is, where do I connect the engine hoist to pull the motor out? I found out where to connect it on the pass side, right by the VC, but I dont know where to connect it on the drivers side.
Also the drive shafts just fall out when I pull the tranny up? right?
thanks soooooo much
-Charlie