Buschur Coil on Plug

[9guy9]

Any one have any experience with the Buschur COP set up? I'm in need of a new coil pack and am tempted to spend the $90 more to get this setup. I don't expect any power gains from it, but it does clean up the engine bay, and will make it easier to run a Sheet metal intake.

Or anyone know of any other choices. I have seen Slowboys but it is quite a bit more expensive.

[JET]

Why not just get a used coil pack?

[Jakey]

Or anyone know of any other choices. I have seen Slowboys but it is quite a bit more expensive.

DV/DT makes one: http://dvdtfab.com/

[At-Least-It's-An-Evo]

Why not just get a used coil pack?


Ditto.

"easier to run a sheet metal"? Not necessarily when you can move the coil pack anywhere you want.

If you want to spend money where it isn't needed, go for it.

[9guy9]

I don't really want to buy another used one (though with my cheap ass ways I might anyways) because i bought the one I have now used, and have had problems with since i got it. THe newest used one I could get is still 11 years old.

And the one DV/DT sells looks really nice in the polished. If only it wasn't $500.

[JET]

Are you sure it isn't your plug wires?

[9guy9]

Ya, I'm sue its the coil. I threw my 2G coils back on without the bracket and it fixed my miss problem. However the coils hanging off the back of the intake manifold by the plug wires is a very temporary fix.

I have already found a used one for $25, so i may just have to go with that.

[tpunx99GSX]

What all do you need to do to use a coil on plug setup? I was looking at the COP setup from DV/DT and that looks really sweet. (the ricer in me talking) and whats the benefit of having a COP setup?

[Enes]

none unless you are making over 700 hp

[tpunx99GSX]

I am making over 700..... ok maybe not, but is there any downside to haveing this?