Will this work ok for porting or?

[howslowcanyougo]

Got a nice 2G Exhaust mani off this board that I was thinking about porting myself, do you guys think this INGERSOLL Die Cutter would work out ok to complete this kind of job?

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=4553845602&category=63693


TIA......


Howie

[unreal808]

Yes.

[JET]

Yeah, that would work, then you need the carbide bits, grinding stones and polishing wheels. Figure at least $40 in bits.

[howslowcanyougo]

Yeah, that would work, then you need the carbide bits, grinding stones and polishing wheels. Figure at least $40 in bits.

Ok, so what would you or Mike typicaly charge for a descent port on a 2G mani then?

[JET]

I charge $60 for an exhaust manifold.

[9guy9]

I got a grinder just like that off the local SK/Cheap tool truck for like $30. I've been using it at work almost daily, for over a year. You might want to check around local. Most of the cheaper ones are the same with different names slaped on them.

This place has some nice bits at a good price. http://www.harborfreight.com/

[howslowcanyougo]

I charge $60 for an exhaust manifold.


I'll PM you later on this k?


Thx.....

[howslowcanyougo]

I got a grinder just like that off the local SK/Cheap tool truck for like $30. I've been using it at work almost daily, for over a year. You might want to check around local. Most of the cheaper ones are the same with different names slaped on them.

This place has some nice bits at a good price. http://www.harborfreight.com/


Thanks much for the good info!