*CANCELED*July 17 DSMStyle.com Dyno day @ Elite Autosport

[Shane@DBPerformance]

So on the "no tuning part." There will be time to check the o2 readings and just do a couple quick adjustments between runs right??? Or else everyone would only need one pull.

Yea, there will be a few moments between pulls. Most people want to do 2 or 3 baseline pulls even if they aren't changing settings, because cars don't do the same thing everytime. Turbo cars are especially sensitive to heat buildup. So people will often do a cool run and then instantly backup it up with some hot runs to see how the power and fueling changes when the car is hot.


It doesn't look like I will be able to dyno either after breaking another built tranny. I was hoping to knock Brent's old AWD number down.

[clean2g]

I'm ready, just don't know if I made the list or not.

[Jana]

You have a pretty good chance considering the number who appear won't be ready on time. :)

[TheBlizzard]

I might get up there and do a few pulls in the Laser to see how good of a tune it has right now after the new injectors and AFC.

[JET]

Alright, this lit a fire under my ass! It looks like I might have a shot to have the car running this weekend if everything goes well. Now I just have to get a hold of Shane to see if I can get some tuning done next week!

[Onefast99gsx]

Never dyno'd my car before. Say I drove up there, what would i have to do to pre-prep my 99GSX before she could go on the dyno? I'd be coming from WI, so it's not like i would want to tear too much apart.

Thanks.

[Jana]

You'd have to be converted to FWD prior to dynoing, and be sure your name is on our list, which means you need to be sure you are going to do it or not...

[AJ]

At this point I don't want any maybe's. Honestly we get that to often. But the fact is the more people that are on the list ready to rock means the more people we can get on the dyno.

Onefast99gsx: If your coming from WI and want to dyno all I need to know is how serious you are. You'd need to have a welded VC and be able to convert the car to FWD before heading on the dyno. If it needs to be done in the parking lot bring a jack and jack stands and tools.

I don't want everyone looking to Eltie to pass out tools for working on cars.


Again we have current list. This week I will contact everyone on the list via PM to confirm by sunday. So if you still want to be added let me know.

[Onefast99gsx]

My dyno time doesn't by no means have to be on the 17th. On the 16th i plan to spend all day at Rock Falls test and tune day so a day at the dyno would probably just be too much to do in that same weekend. Saying that though, i want to have it done at some point in the near future. I was mearly inquiring about what's involved. I would need to see where i can get a welded VC firstly. Dropping the transfer case could be done pretty easily.

[TheBlizzard]

Just PM someone from Elite or give them a call and set up a time to get on the dyno for tuning. Check out their member section on this site for times and pricing.