resurfacing...

[unreal808]

I also cross drilled my flywheel, than chucked it up in the brake lath and cut it so it shakes to off set to my balance shaft .

[1slowdsm]

My cousin was also telling me to just sand the flywheel down a little and it should be fine and I was like..."Arumm...are you sure?" I dont want to take that risk and have to take out the clutch all over again within a couple of months....that'll just suck!
Nvm, I found out where Red Rooster is located. I'll give them a call tomorrow and see if they're better of Bumper-to-Bumper is better.
Still wanna know what Unreal meant up there about 5 replies ago if anyone knows what he meant. :)

[JET]

I also cross drilled my flywheel, than chucked it up in the brake lath and cut it so it shacks off set to my balance shaft .
Did you get it slotted too? I heard that helps release the gases that build up between the clutch disc and pressure plate. :p

[unreal808]

My cousin was also telling me to just sand the flywheel down a little and it should be fine and I was like..."Arumm...are you sure?" I dont want to take that risk and have to take out the clutch all over again within a couple of months....that'll just suck!
Nvm, I found out where Red Rooster is located. I'll give them a call tomorrow and see if they're better of Bumper-to-Bumper is better.
Still wanna know what Unreal meant up there about 5 replies ago if anyone knows what he meant. :)

I would not sand the flywheel if you care about the clutch, I sanded the flywheel on the Talon AWD, but I put in a used clutch disk from my laser FWD.