Log in

View Full Version : Problem Diagnosis...Throwing Belts

Pages : [1] 2
GSXMatt
02-04-2005, 10:10 PM
Alright so a few weeks ago I was out playing in my GSX. Suddenely the car lurched and I lost power steering and stuff.

Basically threw my Water Pump/Alternator Belt, and the Power steering belt went as well.

Alright so got that fixed, found another problem, and fixed that as well.


I left tonight to go wash my car because it was dirty as hell. Just as I got into the carwash, it made the same lurch it did before, and I knew that it had just thrown the same belts.

Why is it doing this? I called Dane and he said it had happened to his Galant and it may be a Harmonic Balancer.

Any other ideas? Or is it indeed the Balancer? Thanks for any replies!!
TheBlizzard
02-04-2005, 10:13 PM
Move to correct section. FUCK!

CRAIG
MustGoFaster
02-04-2005, 10:53 PM
Umm, try moving the balancer, if it's dead you should be able to slide it in and out on the carnkshaft.
unreal808
02-04-2005, 11:09 PM
My balancer could not move by hand. Start the car and look at the balancer from the top, see how true it spins any static, left to right or dynamic, up and down than the balancer is shot, also you may have an oil leak from the bad balancer and the added vibration like I did. Dam I'm tired I'm going to sleep. zzzzzzzzzzzzzzzzzzzzz
MATCHBX
02-04-2005, 11:36 PM
I had that same problem when my balancer went out. I found out when I looked down at the spinning crankshaft (with the new belt on) and saw it moving in and out slightly. It almost looked like it was bent but the rubber inside there had worn to the point that it became a 2 piece crankshaft pulley (2 separate pieces).
Matt D.
02-05-2005, 01:44 AM
Do you have the water pump pulley on backwards?
GSXMatt
02-05-2005, 04:37 AM
Do you have the water pump pulley on backwards?
Not that I know of?
santa
02-05-2005, 07:15 AM
Miss alignment will deffinatly do that to belts. Check all of it out running and not running. Tighten the belts up some more also.

Kevin
JET
02-05-2005, 12:25 PM
Do you have the water pump pulley on backwards?
My vote goes for this too.
MATCHBX
02-05-2005, 11:28 PM
My vote goes for this too.

Unless he took off the water pump pulley sometime in the very near past, I don't know why this would be a problem. There would have been no reason for him to take off the pulley if he only replaced an alt. belt.