Good snap ring pliers?

[IndiEP]

What snap ring pliers are some of you using? I’m having a heck of a time finding a pair that will open wide enough for turbos.

[LightningGSX]

Snappy or MAC tools

[IndiEP]

okay heres what I've found so far, neither gives the opening width.
Mac:
http://www.mactools.com/ProductDetails.aspx?ItemNum=SR-SET

Craftsman (out of stock since mid December):
http://www.sears.com/sr/javasr/product.do?BV_UseBVCookie=Yes&vertical=TOOL&pid=00945358000

[MATCHBX]

Those are both too small for what you need. They will either bend or snap when you try to get the big snap ring out of the turbo. Go with a little beefier snap-on or Mac or Matco. Otherwise you could borrow the one that I have.

[IndiEP]

I appreciate the offer to use yours but the reason why I'm looking now is 'cause I don't need any. And because this is a late christmas gift, I was to busy before christmas to find the right pliers. Where did you get yours from though?

Snap on stops by work so I'll look into that along w/the mentioned brands.

[LightningGSX]

They're pretty much the same off all 3 tool trucks.The snappy ones are the most expensive(of course), the mac and matco ones are reasonably priced though.