Car Wont Idle

[stikx]

when i start the car it wont idle and dies (shuts off)....if i rev then shift into a gear then its fine and goes as normal...after a short drive it would idle fine too.. a guy told me that my IAC is messed up...any ideas????? An IAC isnt cheap so i want to make sure its the problem.

[TheBlizzard]

Coolant temp sensor.

CRAIG

Reason:

If your coolant temp sensor is faulty your cars ECU will thing the air is something like 600degrees F, so the fuel map for starting will be all messed up. Not sure why it would act like that when its still warm out. Usually it only happens when it gets down below 20 or 30 degrees. But I would check there first, then check your MAF for problems also.

Oh yeah, does it throw a CEL at all? A good sign of a sensor is when the car will run like crap and be acting up and then it will throw CEL then start running half way decent. Thats the car bypassing the sensor.

[john]

Check vfaq.com. I believe there is a way to check the sensors for resistance. Or you can look at this as a time to upgrade to a 1g TB.

[JET]

Is your MAS hacked? Also, do a boost leak test. Is the BOV vented to atmosphere? All of those will let in unmetered air at idle, so get those fixed.

[Goat Blower]

The coolant sensor throws an immediate CE light.

[TheBlizzard]

Originally posted by Goat Blower@Aug 21 2004, 10:55 PM
The coolant sensor throws an immediate CE light.
Actually it won't through the code until the ECU sees that there is a problem, it is not right away however, it is usually about 20-30 seconds after start up (if you can keep it running by feathering the throttle). Once it throws the code it will idle fine, that is because the ECU is bypassing the sensor and putting the car into a limp mode fuel map. Atleast this is what I have experienced in the past personally. Some cars might be different though.

CRAIG

[stikx]

Mas is hacked lower side honeycomb is out and i will check for a boost leak.

[nightstalker]

Heard u should only take the honey comb out in 1st gens, b/c it messes up 2nd gens. But thats just ppl i kno talkin

[91 tuner]

I had the same problem, pulled my codes and it was the coolant tem sensor well the wire had broke off.

[illz]

Originally posted by nightstalker@Aug 24 2004, 12:49 AM
Heard u should only take the honey comb out in 1st gens, b/c it messes up 2nd gens. But thats just ppl i kno talkin
no.




also, ISC's are $50. Mail gabor (at) dsmdecals.com , he charges $4 for shipping.