PDA

View Full Version : Valve Knocking Hardcore

Pages : 1 2 [3]
b00stingsx
07-07-2004, 03:32 AM
There are 4 marks on the timing cover, which one is zero though? There is a 10 mark but thats it. The other 3 marks arent numbered.
joem
07-07-2004, 07:00 AM
the other side of 10. 10---?---?---0
joe
Pushit2.0
07-07-2004, 09:09 AM
It is marked, for 15, 10, 5 and 0 TDC. clean off the plastic it probalby has dirt and what not all over it. Also were do you live I could come check it out after work tonight.

~John
(763) 550-2962 I work 1pm-9pm.
b00stingsx
07-07-2004, 12:18 PM
im in edina, tonight isnt good for me though. im gonna go check it to see if it lines up to the zero. I dont think it does...
b00stingsx
07-07-2004, 03:23 PM
it did jump a tooth, is there a way to see if the valves are all bent? or are they bent for sure?
joem
07-07-2004, 03:43 PM
If it jumped less than two tour good replace the belt water pump and tenc. and be done.
joe
JET
07-07-2004, 04:52 PM
Originally posted by joem@Jul 7 2004, 02:43 PM
If it jumped less than two tour good replace the belt water pump and tenc. and be done.
joe
Engrish man, Engrish!!

If it just jumped one tooth you should be ok. If it jumped 2 teeth, then you may have problems. Over 2 teeth and you are almost definately in trouble. Check out the VFAQ's for items to buy.

JET
Raptor
07-07-2004, 09:03 PM
If you need me to I can come check it out with the boroscope to make sure there isn't valve to piston damage. Call the shop if you want more info. QPR that is.
b00stingsx
07-08-2004, 01:44 PM
ok, how dirty is is supposed to be inside the timing belt cover. its reallly greasy and dirty? Can I just get a timing belt from checker or should I go to mitsu? How about a waterpump? just wondering because i get a deal through csk proshop, making things alot cheaper.

also, what is the procedure to line up all the timing marks since my belt jumped a tooth?
john
07-08-2004, 04:46 PM
I would buy the parts through Mitsu. You may as well replace the water pump and maybe the tensioner while you are in there. How long has it been since your car has had a t-belt job? You might as well replace teh b-shaft belt or remove it.

As far as the oil and grease, you may need a seal on the front of your engine. Feel the seals on the front case and see if they are like plastic or rubber.