PDA

View Full Version : Dsmdolney’s street/drag build

Pages : 1 [2]
dsmDolney
06-24-2018, 09:21 AM
Got alot of stuff done tonight to wrap this thing up. Got the fuel lines all done and everything hooked up, installed and wired in the aem gauges, installed the jay racing alternator relocation, and a bunch more misc things that needed to be done. Slowly getting there.
turbotalon1g
06-24-2018, 09:26 AM
Looks good man, who did the welding on the VC for you?

It looks really close.
dsmDolney
06-24-2018, 01:27 PM
Looks good man, who did the welding on the VC for you?

It looks really close.

bought the valve cover with the fittings welded on already so not exactly sure who did it.
dsmDolney
07-19-2018, 10:50 PM
Fenders, hood, front bumper all mounted up and still have to make a heat sheild for the side exit exhaust. Trying to make this thing ready for the cookout so we are trying to bust it out now.
dsmDolney
09-05-2018, 10:56 PM
Well we wrapped up the engine bay tonight, all that is left is fluids and we are ready to start it. We hope to make it to Pg with the car next weekend but it will be cutting it close.
dsmDolney
10-06-2018, 03:42 PM
Some billet goodness. Dont mind the nasty clamps they will be replaced
dsmDolney
10-10-2018, 04:10 PM
The car is a rollin. Few small things that need to be addressed then we will look into getting dyno time to see what this little 16g can put down. Also in the near future I plan on swapping coilovers in instead of the kyb / megan shock and spring setup we have in it now which sits way to low for me.
C3L1CA
10-11-2018, 06:52 AM
Anybody else have issues opening the attachments?

From the little thumbnails it looks really clean and well done
AwdGSX13
10-11-2018, 07:54 AM
Anybody else have issues opening the attachments?

From the little thumbnails it looks really clean and well done

attachments have not worked in some time it seems. Not sure what the deal is.