FS: DIY - DSM SMIM Parts

[Halon]

I still have my parts from a long time back when I was going to make my own intake manifold for my Talon. I don't even own a DSM anymore so no use for it, lol.

- 4" x 4" x 1/8" wall (16" long) - Square extruded Aluminum to act as plenum

- 4" x 1/2" thick (16" long) - Aluminum plate to act as the bottom of the plenum for radiused holes

- (2) 4" x 4 x 1/2" thick - Aluminum plates to go on the ends of the plenum (one of which you would drill/cut to be TB flange)

- 3/8" thick aluminum Intake Manifold Head flange (I believe these were for 1G sized ports).


Only thing you still need is some 2 1/4" piping for the runners.

I was basically going to mimic this guys setup
http://www.dsmtuners.com/threads/build-your-own-intake-manifold.273139/


$55 shipped

$35 if you come pick it up.


http://mitsustyle.com/forums/attachment.php?attachmentid=16149&stc=1&d=1475184490

http://mitsustyle.com/forums/attachment.php?attachmentid=16150&stc=1&d=1475184490

http://mitsustyle.com/forums/attachment.php?attachmentid=16151&stc=1&d=1475184490

http://mitsustyle.com/forums/attachment.php?attachmentid=16152&stc=1&d=1475184490

http://mitsustyle.com/forums/attachment.php?attachmentid=16153&stc=1&d=1475184490