Roll cage build

[talonsway]

http://www.mitsustyle.com/photopost/data/500/medium/Picture_154.jpg

http://www.mitsustyle.com/photopost/data/524/medium/Picture_159.jpg

Found this picture on dsmtalk, member was actually from MN, Love the detachable door bars, and the whole design.

[talonsway]

Found some more pictures of a setup, there almost all similar in some way. I will hopefully be starting to build my cage next week, once I finish working in the trunk area.

http://i103.photobucket.com/albums/m153/bluemeanietsi/CIMG1183-1.jpg

http://i103.photobucket.com/albums/m153/bluemeanietsi/CIMG1184.jpg

[talonsway]

http://img.photobucket.com/albums/v683/Jaycoop/CIMG1193.jpg
http://img.photobucket.com/albums/v683/Jaycoop/CIMG1186.jpg

[Pushit2.0]

The "D" bars need to go to a frame rail, which a unibody car does not have. So what we do is run a tube between the bottom of the main hoop, either straight above the tunnel or bend it so it fallows the floor, then weld the "D" bars to that. Also having 2 or 3 6x6 plates that tie in the floor structure at the main hoop floor connection is best. The tube size would be your standard 1 5/8" .083 wall DOM chrome moly or 1 5/8" .125" wall DOM mild steel, or a 2" x 3" .125" wall mild steel box tubing.

~John

[twack]

Pretty sure that white 2g's cage was made by Eclipsegst / Jake on this site. Brings back some good memories from those days