un cut 6 bolt crank

[DSMINMN]

$366 isn't bad when comparing to the alternative. Eagle junk for $500ish or Manley for 6. Crankshaft supply is the beesneez around here. They don't carry any 4g cranks down there? Would almost think they would.

Good luck on the decision.

[plow420]

Crankshaft Supply don't have any stock of 6 bolt cranks. I wish i knew of them sooner. I've trashed 3 cranks because they needed to be cut.

I also have a set of acl tri metals sitting in my garage, I'm thinking about going to aluminum. I haven't had the best luck with the tri metals.

Anyone with experience with aluminum bearings around 500 whp.

[punxnotdead185]

You can cut 7 bolt cranks .010 and be fine, they are induction hardened and the hardening layer is .025-.030 deep, a 6 bolt crank is nitrided and that only goes .010-.015 deep so a basic .010 cut could remove the hardening off the journal.