Winter mods 2013/2014

[turbotalon1g]

On the owdee -Timing belt, water pump, thermostat and housing, rear coolant valve replacement, VC gasket, and a bunch of other maintenance, figure out why my power steering started to make a grinding noise at full lock in the next few weeks.

Decide if I want to keep it come spring and replace it with something else. Or get a second summer car.

This or ban. :VP2:

[Halon]

:eek:

Going for 40+ psi? :D

No no, just feel like I'd be on the hairy edge with the 1000's, so upgrading to something with a little more breathing room.

[Murlo26]

No no, just feel like I'd be on the hairy edge with the 1000's, so upgrading to something with a little more breathing room.

ID has 1300's, are those not enough?

[Pushit2.0]

Well I do have plans for the race car. I need a motor to last more then 1 season. So to do that I am going to limit my street boost to 40psi and running e98, plus a 75 shot if things go south. Then for track duty I will be going back to c/q16 and no more then a 150 shot, with any luck this will prove to add some reliability to the moon taxi, anything can happen at 8+ awhp per cubic inch. And all I want to do is back up my 9.45 run but now on slicks with a 1.5 60' vs 1.75 on drag radials, Any dang way back to posting Liana up dates.

[evotuner]

Get my 2.3 broke in and tuned. Then some new sticky tires for drag/autox and some road course action. Thats really about it. Maybe a JDM rear bumper if all goes well

[evotuner]

Calm down Murlo just giving you a hard time. I am just jelly I can't swapping turbo set up after set up.

http://i212.photobucket.com/albums/cc73/evotuner04/362E13A9-EEC4-441E-91D5-3BA33963C513-5310-0000031994106F52_zps749896f6.jpg (http://s212.photobucket.com/user/evotuner04/media/362E13A9-EEC4-441E-91D5-3BA33963C513-5310-0000031994106F52_zps749896f6.jpg.html)

[Goat Blower]

1)Drop the rear cradle, replace rear bearings, active toe eliminator and all poly bushings.
2)Quiet down the exhaust a lot.
3)Repaint whole roof and add modern shark radio/GPS antenna.
4)Finish interior dynamat project.
5)Powdercoat RPF1's bronze.
6)Detail and paint engine bay
7)Powdercoat various engine accessories.
8)Upgrade brakes or pads.

[turbotalon1g]

^ you should buy carls turbo

[URV8SUX]

M&W pro 14 and coil on plug to control timing in each cylinder.
Rear wheel speed sensor.
Get better weight distribution front to back.