Pistons & Rod combo or piston's

[Alpha D]

Hey Style,

Im in need of some new or used pistons in good condition with fresh rings or no rings does not matter. I am looking for stock compression numbers. I have a Stock 6Bolt 4G63T That has been bored out to .20 which directly reflects on the piston diameter im in need of. Please let me know what you have. If you dont have a set but know of a good place to perhaps purchase some other then the dealer or expensive after market set's please feel free to share. I am in need of just one or a set just to get the vehicle moving again.

Thank you,

[twisted954]

Realistically, you should bore your block out to MATCH the pistons you are using...if this is what you are doing to bore to .040 then there is a set of wiseco pistons and eagle rods for 250.00 for sale by twitch in the for sale section.

[Alpha D]

I dont think i quite understand your point? Why cant i just replace the unit in my bore with a replica bore size with no damage to my block? Is a Bottle hone before install to rough up the surface not good enough? Is that what you are referring to?

[turbotalon1g]

I have a stock set of big rods and pistons I was going to build a stock motor but well I said F it.

$50 and they are yours.

[Alpha D]

What about the size aaron?

[turbotalon1g]

oh you need .020 over?

I think they are just regular old stockers. You can try them out and let me know if they work.

[93gtpeater]

You could just run .20 over rings. I do this all the time on my sleds. I know it sounds crazy and dumb but a lot of people do it.

[EclipseGST]

Realistically, you should bore your block out to MATCH the pistons you are using...if this is what you are doing to bore to .040 then there is a set of wiseco pistons and eagle rods for 250.00 for sale by twitch in the for sale section.

Those are sold...

[EclipseGST]

You could just run .20 over rings. I do this all the time on my sleds. I know it sounds crazy and dumb but a lot of people do it.

That sounds retarded... I've never heard of anyone doing this on a 4g63, piston slap would be ridiculous!

Alpha, I have 3 that are in very good shape, pretty sure they are like an "OE" replacement but are .020 over. If they could be of any use to you to make a good set out of the originals. Let me know. They were in a block that a valve came loose in one of the cylinders and trashed one piston. They are on 6 bolt big rods. I can get pictures tomorrow night or monday.

[Goat Blower]

I've got a set of new OEM .020" over 1G pistons and rings mounted on 6-bolt rods. A set of rod bearings away from dropping in. $100 cash firm.