twisted954
07-13-2013, 11:05 AM
I have a low mileage HDSS clutch kit with super low miles
I encourage you to check it out...the friction disc looks practically new, the pressure plate is in functional condition, but the paint has chipped off in a lot of places...cosmetically less than new but fully functional. No heat damage, warpage or issues...I removed to run twin disc, but this kit has maybe 2K miles on it. The flywheel is 6 bolt and factory, turned when installed and there is no heat marks...in all honesty, I wouldn't even turn it again...it's perfectly good to go right back in car. This came out of a 2g and it has a (at the time of install) new OEM throw out bearing with clip and fork. This entire kit could go right back into a car and has tons of life left in it...let's just say I normally would just pitch a used clutch, but honestly, there is so much life left in this and it's in such good shape that I don't want to waste it.
150.00 bucks takes it all. Fork, Flywheel, Pressure plate, SS disc, throw out bearing with clip.
Let me know!
I encourage you to check it out...the friction disc looks practically new, the pressure plate is in functional condition, but the paint has chipped off in a lot of places...cosmetically less than new but fully functional. No heat damage, warpage or issues...I removed to run twin disc, but this kit has maybe 2K miles on it. The flywheel is 6 bolt and factory, turned when installed and there is no heat marks...in all honesty, I wouldn't even turn it again...it's perfectly good to go right back in car. This came out of a 2g and it has a (at the time of install) new OEM throw out bearing with clip and fork. This entire kit could go right back into a car and has tons of life left in it...let's just say I normally would just pitch a used clutch, but honestly, there is so much life left in this and it's in such good shape that I don't want to waste it.
150.00 bucks takes it all. Fork, Flywheel, Pressure plate, SS disc, throw out bearing with clip.
Let me know!