Just Got The Evo Dynoed If Anyones Interseted!?!

[Mr Raced]

Well i took my evo to the all wheel dyno that Propulshion has and made a few pulls on it. I got some runs in for free since they havent done any evo's yet and need to know how to strap them down and stuff. With the mods i was running were turbo back exhaust, manual boost controller, and ecu flash i put down 278 awhp and 318 ft/lbs. I have an intake but didnt have it on at this time. This was on 92 octane on a pretty hot car and the boost was spiking at 22 and right away pulling down to 18.5 to 19 psi at redline. I think they are pretty decent for my mods, hope you guys enjoy :cheers:

[Jana]

How'd it go there? (Meaning, were they any good at tuning)

[AJ]

They didn't do any tuning and Ryan doesn't have anything to tune with. Good numbers Ryan. Thanks for swinging down so we could take a look!

[JasonR]

They use a wideband on end of exhaust and can you watch while driving the a/f ratio?

[Mr Raced]

They only have the o2 sensor type one that goes directly into the o2bung on the exhaust.

[A//// Guy]

Nice numbers! So what are their rates anyway for a couple pulls?

[SquackDiddy]

nice #s

[ACRucrazy]

Nice numbers!
That seems about right for your times
Comparison, I was at 265whp and 316Tq

How was the shop?!

[Mr Raced]

The shops not bad at all and the guys are really cool. Remer chris mines awhp :3gears: When are we gonna finally line em up :cheers:

[john]

How much do they charge?