turbomiata
05-02-2012, 06:57 PM
UPDATE: Title now in hand!!!!!
I would like to sell my 1987 conquest project I've had for almost 5 years now. Reason being not enough time and money with a new addition to the family and all.
Its does not run and will need a fair amount of work and a few parts to get it running. But for someone mechanically inclined it should be a fairly easy process.
I would like to sell it for $2000 FIRM, the amount of money i have into the engine alone in parts.
What i have done so far.
I started with a rust free 1987 conquest I picked up in Wisconsin without an engine. Bought a wideblock 2.4l 4g64 block from junkyard, and a dohc head from a member of this form and had them both machined and built with the following:
Engine:
resurfaced and machined
eagle rods
wiseco pistons
acl rod and main bearings
arp main studs and head studs
new front cover
new oil pump parts
all new gaskets and seals
cometic head gasket
Head:
resurfaced
3g hydraulic lifters
brian crower stage 2 cams
Misc Parts:
socketed ecu
evo 8 turbo and manifold
act clutch and flywheel
Magnus rwd intake
3" exhaust
ss fuel lines
As far as what it needs to be up and running. the engine would need to be installed and all plumbing would need to be figured out. For information on the extent of the install checkout this website.
http://projectzerog.com/
I know I am forgetting a bunch of things but if this interests you give me a call to chat and come take a look.
Matt
651-235-4168
FYI
I just transfer the title after 5yrs of owning it, but should be here very soon.
http://i118.photobucket.com/albums/o116/mattcphotos/PIC00002.jpg
http://i118.photobucket.com/albums/o116/mattcphotos/rearsq.jpg
I would like to sell my 1987 conquest project I've had for almost 5 years now. Reason being not enough time and money with a new addition to the family and all.
Its does not run and will need a fair amount of work and a few parts to get it running. But for someone mechanically inclined it should be a fairly easy process.
I would like to sell it for $2000 FIRM, the amount of money i have into the engine alone in parts.
What i have done so far.
I started with a rust free 1987 conquest I picked up in Wisconsin without an engine. Bought a wideblock 2.4l 4g64 block from junkyard, and a dohc head from a member of this form and had them both machined and built with the following:
Engine:
resurfaced and machined
eagle rods
wiseco pistons
acl rod and main bearings
arp main studs and head studs
new front cover
new oil pump parts
all new gaskets and seals
cometic head gasket
Head:
resurfaced
3g hydraulic lifters
brian crower stage 2 cams
Misc Parts:
socketed ecu
evo 8 turbo and manifold
act clutch and flywheel
Magnus rwd intake
3" exhaust
ss fuel lines
As far as what it needs to be up and running. the engine would need to be installed and all plumbing would need to be figured out. For information on the extent of the install checkout this website.
http://projectzerog.com/
I know I am forgetting a bunch of things but if this interests you give me a call to chat and come take a look.
Matt
651-235-4168
FYI
I just transfer the title after 5yrs of owning it, but should be here very soon.
http://i118.photobucket.com/albums/o116/mattcphotos/PIC00002.jpg
http://i118.photobucket.com/albums/o116/mattcphotos/rearsq.jpg