Beware! 1G4g63t

[Fran05]

I had a misfortune to deal with this individual. I wish I would have never met him.
He was trying to sell me a maroon 1G of his with a horrid rod knock. You can't hear it from inside the car and at idle under the hood. Only if you rev it beyond 3k, it appears, terrible, obvious, brutal rod knock.

I talked to him for an hour while he was driving the car back to his house, and then I was supposed to drive it home 200 miles. He has obvious mechanical background.

He knew it all long (his build thread claims: "So now I have a rattling noise at 2900rpm). Upon asking him over the phone, he said: "It was just a heatshield". I trusted the guy. What a mistake. He lied right in my face.
He wasted my time and money and almost sold me a piece of shit. Almost.

Watch out.

[Alpha D]

Dang, sorry to hear that.

[1G4g63t]

ok so now I feel like I have to say something. First a rod knock would be heard constantly and it would get louder and cause other issues as the engine revs up. but out of curiosity I dropped my pan to check bearings and found nothing wrong. it's had the same sound at 2900rpm for almost 4 months and I put about 200 miles a week driving to work every day. so before you cry rod knock learn a little about engines. chances are since my clutch is going bad thats where the sound is coming from.

[93gtpeater]

Never heard of rod knock at 2900 rpms and not at idle. when you have rod knock it should make a noise all the time. And if he has been putting 200 miles on it a week I doubt it would still be running.

[blackrosenova400]

Actually you could hear rod knock at a higher engine speed and not hear it at a lower speed as cylinder pressure is higher. Just depends how bad it is.

[niterydr]

I've heard rod knock at speed but not at idle as well. Have you tired pulling plugs to isolate the cylinder?
TOB could also make noise, but that should change with engagement/disengagement.
Any upper end noise?

[1G4g63t]

I have not tried the clutch idea yet. just wanted to prove this kid wrong so I dropped my pan to look at bearings and check the rods, every thing is as it should be. I'm gonna look into this issue deeper just to be absolutely certain what the problem is. but in the end I'm still selling the car.

[Swanny]

lifters real bad?

[1G4g63t]

Pretty sure they aren't. Like I said I'm gonna figure this out. at least so I can tell who ever buys it what the sound is. I'm putting the stock cams back in and giving my 272s to my buddy so I'll check lifters then. but I've gotta get rid of the car soon because I just got a notice from the city saying that I have too many cars outside my house.

[tpunx99GSX]

How is the crank end play? Sounds like the same noise my old 2g made before it crankwalked. Started very quiet, almost like it wasnt there, but then when you got above 3000 you could hear it. I drove the car like this looking everywhere for the issue for about a month or two, but then it finally gave way and died on the freeway.