7-bolt

[DSMINMN]

I am looking for a 7-bolt 4g63t. It is going to be the new engine for my Talon. I am going to be completely rebuilding it so it can be a bare-block, short-block or even a long-block. I would like to spend as little as I possibly can.

The engine year does not necessarily matter. A late (97-99) block would be favorable but it does not matter.

Let me know what you guys have, thanks.

[longemoco]

I have a bare block, from 97-99, it has been bored .20,honed and milled.also have a crank for same block along with matching rod and crank bearings, also a topline engine gasket kit,

[TkrPerformance]

I have 2 dsm 7bolts and a evo 3 7bolt block it has 1g oil squiters in it.
take 40.00 for a 2g block or 60.00 for the evo 3 block

[DSMINMN]

I have a bare block, from 97-99, it has been bored .20,honed and milled.also have a crank for same block along with matching rod and crank bearings, also a topline engine gasket kit,

Well I plan on having it bored .40 over and the works done to it. Also I will be getting a 100mm crank for it.

[DSMINMN]

I have 2 dsm 7bolts and a evo 3 7bolt block it has 1g oil squiters in it.
take 40.00 for a 2g block or 60.00 for the evo 3 block

Is there any gain from running an evoIII block instead of a 2g block?

[TkrPerformance]

It has the good oil squiters in so you would not have to have them machined into the block. Also less prone for walk

[DSMINMN]

It has the good oil squiters in so you would not have to have them machined into the block. Also less prone for walk
Sounds good to me!!