Any tips when installing cams on a 1g

[93gtpeater]

I would like to install my new cams today when I get off. I want to do it right the firs 2g time and not mess up anything when I put them in. so does anybody have any tips on what to do and what not to do?

[mike55112]

Do one cam at a time, use antisieze on the threaded rod to remove tension. I just did cams yesterday on my evo and it was a lot easier than I expected for my first time. Just take your time and torque everything to spec

[turbotalon1g]

Remove tension a bit zip tie/adhere belt to gears, pull off gears swap cams, put gears back on an voila new cams installed in under an hour and timing is dead on.

[93gtpeater]

Thanks guys. But iam putting cams in now cause it needs a new timing belt. figure if iam putting a belt on mine as while put cams in.

[blackawdtsi]

Make sure arrows are where they need to be, dowel pins are UP and tighten your new bolts if you are putting in adjustable cam gears.

[1QUICK4]

Don't forget to bleed your hydraulic lifters or you "could" bend valves

[93gtpeater]

I didnt know you had to bleed the lifters

[Swanny]

You dont

[desolate]

Cam caps torque 17ft lbs to add in for quick reference. Lol I didn't see it was 3 weeks ago.