91 Galant VR4 part out

[CarRacer]

I'm tearing apart my car and figured I'd see if you guys needed anything before I junked the shell.

I'm keeping the motor and I'll list the drivetrain and bigger money stuff separately. This listing is basically to get you guys anything you need of the smaller or obscure bits, like interior, bolts, wiring, etc.

Shell is rusty and every body panel has a blemish. The car hit a guardrail in the blizzard this winter so the RF and RR are damaged. Car was still drivable but the body is beat up.

Car is located in Prior Lake, I work in Edina. Able to meet near those cities. Let me know what you guys need.

[Andrew7dg]

Are the breaks in good condition?

I am looking for the 4 bolt front knuckles and possibly the 4 bolt rear hubs

[CarRacer]

Brakes have new pads and SS lines all around. Rotors are just stock and I don't recall how much material is left.

Front bearings have about a year on them and rears were replaced this past fall.

[Alpha D]

Interested in the Fuel pressure regulator. If its even for sale.

[CarRacer]

Sorry, I'm keeping that as well.

[Pushit2.0]

I need 2 front corner lights and the front window upper trim piece, do you have them?

[CarRacer]

RF corner light ate it. Not sure what condition the trim is in. I know there's some surface rust on the upper A pillar. I'll try and remove it and contact you after I do.

[OMFGeofffff]

How is the hood and trunk lid? I might be interested in the dash, plastic interior trim that runs above drivers doors, plastic instrument cluster trim, rear doglegs...I'm not sure what else.

[CarRacer]

Hood is bent, trunk may be damaged as well. RR dogleg is mia. I'm not going to pull the dash.

I can get you the plastic trim. $5/part.

[OMFGeofffff]

I'm down to meet today or tomorrow(Thursday) to pick up that trim. You wouldn't happen to have a good a/c condenser would you?