Throttle Body Question

[Halon]

If you loop it, you should put on an FIAV blockoff plate on it. Or else you will be letting a small amount of air passed the TB plate all the time, which was only meant to be during warm-up.

[C3L1CA]

You could just machine a plate plate and block off the whole bottom of the throttle body. It wont idle at all cold and you have to keep your foot on the gas until it is warm but you could make a whole block off plate yourself if you're cheap.

[SpyderGSX07]

the heater core is pulled... again.. i pulled all of the hvac shit out. blower motor.. evap. HEATER CORE... and all of the plastic pieces with it all.. there is NOTHING under the dash. and there wasnt any point in having the heater core in. the blower motor wasnt working. so the heater core would basically heat soak and be pointless. as for the throttle body?? im leaving the coolant lines run to it. no point in having my car run like shit until it warms up because i wanted to loop some lines..

[asshanson]

Good to hear about the keeping the lines to the TB.
Curious why you didn't just replace the blower motor and have heat?

[SpyderGSX07]

because i didnt want to deal with the wiring problems. i didnt see it worth it. its a convertible.. i dont drive in the rain, winter, or cold. its not my dd. its my "project" car. so i said efff it im pullin it all out.