WTB: 2.5" Stainless Mandrel Bends

[Halon]

Anyone have some 2.5" stainless bends locally before I start shopping ebay? Or even an old 2.5" stainless exhaust or old IC piping or whatever. Anything that I can cut up to use for the exhaust on Teh Bean.

Mainly looking for 304SS, none of that 409 crap, and no mild steel. And of course, the cheaper the better, and donations are the best!! :D

[TkrPerformance]

http://www.heartthrobexhaust.com/
it is where I get all my bends

[95talonracer]

I have some foo.

[Sparky2211]

I may have a couple. What kind of bends are you looking for?

[Halon]

Ideally I'd end up with four 45* bends and a U bend. But will work with whatever I can get on teh cheap.

[Sparky2211]

I don't have any U bends, but I am almost certain that I have 45-degree. I just need to verify the material for you. They are yours for free if you comes get them.

[asshanson]

I have a large 2.5" SS pipe, it's a big U-bend, but you could cut it apart into some 45's if you want. It's the larger pipe near the bottom of the picture (next to my free resonator haha): http://mitsustyle.com/forums/attachment.php?attachmentid=11047

The bend isn't very tight so I'm not sure if you want to use it or not, but it's free!

[Halon]

Andrew that'd be perfect.

Sparky that also sounds good. Just lemme know what you have. Where you located at?

[asshanson]

When do you need this by? Not sure the next time I'll be in the cities, I could ship it though.

[Halon]

When do you think you'd be in town again? I'd think I'd be interested in trying to get it within the next 3 weeks or so...