What do you think of the g4cs

[Goat Blower]

You can reuse your Eagle rods on your 2.4 build and unless you're building a drag car, I'd do the stock 2.4 cam gears and belt and not mess with degreed cams, especially with HKS's since they install straight up. With a 2G head and a good turbo, you'll have a V8 torque curve and awesome streetability.

[plow420]

I would just buy another Eagle rod and crank but i cannot find a 6 bolt crank. Then i would need new bearings and new piston rings, and hone the block. When i can get a running engine for 200 and put my head on it and get a new hg and call it good.

[95talonracer]

You will find out why you shouldnt just slap a HG and head on it and "call it good" later if you dont want to take peoples advise. you will get out of what you put into it just remember that.

[scheides]

I was using rotella 15w 40 when the bearing spun. Had under 1k miles on the oil when the rod spun.

And how much where you looking to get for the adj. cam gears that you have.

I know i don't have a mod list but i do have most the part pics on my fb page if anyone cares to look

http://www.facebook.com/album.php?aid=60918&id=504713394&l=5735c2a155

Dude you have what looks like a pretty nice setup going there! You need to start a project thread and bring us up to speed, very nice.

[plow420]

Dude you have what looks like a pretty nice setup going there! You need to start a project thread and bring us up to speed, very nice.

When i have time i will try to start a project thread. I know its way over due on my build.