Suspension

[Enes]

Ok, i've done about 6 cars different suspension, however i haven't touched any eclipses suspensions..

Now i started off with fronts because those are harder usualy..and first i had to run into issues as usual...

well long story short, i can't remove the bottom bolt..
http://vfaq.com/proj-pics/GCkit/2G/GCfront-03.jpg

i removed the nut, and i am trying to pound it out and it won't go! i tried unscrewing it out, and it don't look like its going either.. i might just leave it in and take it out together with the arm and everything but its just stupidly hard.. what if i need to remove it at one point or another!!!

-E

[v8klla]

did you try removing the lower ball joint nut? That should take pressure off of that point aqnd hopefully it will slide out...

Chris

[A//// Guy]

Yea you have to release the pressure so the whole wheel unit and hub isnt sitting on those bolts. Drop the Balljoint, or jack up the hub and everything a little so it take pressure off the bolt and try sliding it out.

[Enes]

guys, i have it disconected on the other side... nothing is standing on that part, the axle weight is about the only thing putting preasure on it.


-E

[JET]

BFH??

[Enes]

a 10 lb sledge couldn't take it off.. i had to cut it, now i don't know how to remove it either.. fuker is stuck.. i think about the only/best option now is to remove the axle from the wheel and remove the freaken thing as one peace. go to junk yard and get a used new one... i'm sure a dealer would want both arms for that one..
-E

[Enes]

http://www.enesg.com/gallery/albums/eclipse/IMG_2782.sized.jpg

The bolt was stuck in there so i ended up cuting the nut and the other end of the bolt so that i can remove the suspension.
http://www.enesg.com/gallery/albums/eclipse/IMG_2785.sized.jpg

the missing part of the bolt is stuck in the suspension as you saw in previous picture...

I tried to pound it out with a 10lb sledge and it would NOT budge...

-E

[fmicmatt]

I broke/cut 4 of those bolts in my rear susp. while putting in poly bushings.

Order the caster?/camber?/whatever alignment bolts (2ea) for the rear if stuff looks rusty. They are a specilty bolt that cannot be replaced with a regular bolt to get by for a little while........or drive home.
Don't ask me how I know.

Sawz-Alls Rock!

-Matt

[Enes]

what do you mean speciality bolt? the rear bolts on the upper u arm? the ones that bolt to the frame of the car? and camber kit for the back is just a simple freaken set of washers with longer bolts.. that is all. Last time i used 5 washers on 1.6" drop on the stratus. so i assumen i should be doing 6 still on this current 1.5 drop.

-E

[Enes]

Does anyone have a suspension diagram for that? i need to find out the torq specs of each bolt and maybe hopefully part numbers..

-E