Piston Rings?

[santa]

Does anyone know where a good place other than the dealer to buy stock piston rings? the dealer gave me a $145 price anyone below that around here?

[Raptor]

We had to get .050" over for a set of 2G pistons and they were $150 from turbotrix. Stock rings are way overpriced IMO. Not sure if there is a much better deal around, Allan could tell you, he did the looking.

[AJ]

You could try Concellie (sp?) but yeah they are a bit over priced. Probably best price would be if you worked at a dealership or something and got cost or close.

[MustGoFaster]

http://www.mitsubishiparts.net/ is fairly cheap. You need the part number though. Just get it from Concellie (sp?) and paste it in. Was like $108 or so I think.

[Kracka]

Chris Cabe can give us pretty good prices at Brookdale Mitsu, he has always been cheaper than Conicelli for me.

[Raptor]

We usually go through them as well, but I don't think they could give us much of a break on the rings we were looking for. Maybe they will be able to get yours at a better price, worth a try.

[santa]

1quick4 is looking into his dealer price i believe its around $100 through him? this is for 1g stock piston's btw 6 bolt... like it matters

[520Talon]

It matters to me!! I am finally going to get my heap up and running. 1G stock rings and bearings are on my list. If you can find them cheap do forget to drop me a line.

I've mannaged to fill four gallon milk jugs begging downtown on weekends for my rebuild money and I think it will be enough. Note to self, need to bring three legged dog with me next time, she gets way more than I do! :banana:

[santa]

try cranck shaft supply in st paul for bearings there cheap and hell and there clevete

[npaulseth]

How much time/how difficult is it to change the piston rings if the short block is already out of the car?