2G/1G, piston and rod combo cost.

[turbotalon1g]

i was talking 2g piston & 1g rod combo. I was looking to build a stock bottom end to try and chase Brad but it looks like everyone wants to swear off a 2g piston/1g rod combo, plus I would only do it if the motor needed it.

I'm hoping to get it together asap just to work out bugs.

[Shane@DBPerformance]

Brad's on low compression 1G pistons. Must be why he can run 38psi and a 100shot of nitrous and not knock.

[turbotalon1g]

^Thanks for clearing that up big guy.

[Super Bleeder!!]

Just stick with 1g pistons d00d.

[C3L1CA]

Brad's on low compression 1G pistons. Must be why he can run 38psi and a 100shot of nitrous and not knock.

Don't forget an amazing tune ;). I've never ran more than 32/33psi and 100 shot though. I'm a wuss:nod:

[turbotalon1g]

.

[turbotalon1g]

Just stick with 1g pistons d00d.

^Trust me I hope i have to

[Shane@DBPerformance]

I've never ran more than 32/33psi

O'rly?

http://dbptuning.com/dyno/line_graph_dyno.php?_jpg_csimd=1&content_id=&sent=true&dyno_run_list=33&points=N&width=900&height=500&rpm_mph=rpm&data_type=hptqboost

I guess never above 33psi or whatever with the nitrous. :)

[jrohner]

Holy crap! $200 to bore out the rods 1mm and press four pins in? I just had Wagamon Bros do mine for $100, it took them a month to do it though.

And resize for ARP rod bolts, forgot to mention that.


It's $165 at thedsmgraveyard.com

[turbotalon1g]

B rad you lying sack of shit.
I'll be starting a project thread soon and you will all be updated.