Im a dsmer again!

[slowbubblecar]

^ha ha ha. I forgot about that

[1ViciousGSX]

Don't forget about the fire sale.

[tpunx99GSX]

Don't forget about the fire sale.

did you not see the picture earlier? eyes must be leavin ya old man. :)

[GSXMatt]

Man I wish I could post the video of when you had Oko and Ryan in the car and Oko was asking if you ran 12s. Good times.

[tpunx99GSX]

well im at the oil pan now, getting ready to drop it, just need to warm up my fingers a bit. I have 7 or 8 bolts off now, two of them are going to be a real bitch. Aftermarket oil pan for the loss. :)

[tpunx99GSX]

By the way...
Does anyone local or close to maple grove have any moly lube for the bearings? or know where i can get some?
I found my torque wrench, i thought i had left it in california but turns out it was in the back of one of the drawers in my box.

[tpunx99GSX]

NO DAMAGE TO THE CRANK!!!! WOOO WOOO. Looks smooth as a babys bottom. no scratchs or anything. The rod cap did fall off on the number 4 piston. (by the way, manley rods look freakin beautiful). I will be needing 1 rod bolt though because it was bent. on the rod itself towards the outer edge where the bolt screws into will need to be grinded just a tad in order for the rod cap to sit flush again because there was a gouge in it. im just super thankful there was no damage to the crank or the rod where the bearing goes.

[asshanson]

There was just a thread on where to get ARP moly lube, go to DB, it's close to MG.
Unless you're just talking about assembly lube, then any oreillys should have that.

edit: I'd also consider buying a new rod at that point. Why mess around with gouged parts that you had to file down to fit right, especially on a part like that. Plus the rod bolt bent? Sounds like it's pretty messed up.

[TkrPerformance]

Just got to orilleys for the lube. I would go to the one in brooklyn center off of john martin drive and hwy 100. Craig on here is the manager of the store and we have a huge style discount there.

[asshanson]

Actually I have a huge tube of moly assembly lube, you can use it if you want, I'll probably never use it all. Come to the meet on Wednesday and I'll bring it.