3/s 4 piston calipers, who's using them?

[Chim55117]

I called my brother. Yes, they are 3000GT VR-4 4 pistons. It says Mitsubishi on each caliper.

[Constant_Project21]

Sweet, I might have to stop by and take a look at how those are set up...

[Chim55117]

Sweet, I might have to stop by and take a look at how those are set up...

Anytime. Give me a text sometime and I'll let you know if I'm free to show you the VR-4. It's in storage in Arden Hills.

[Constant_Project21]

That's kinda shitty, all I really need to see are the brackets, but that would require disassembly...Hmm

[s1ngletracker]

me. on my 3/s :)

But really, someone should take a set to primo and have them do some low-cost reproductions for the rest of us! :)

[Constant_Project21]

That was kinda the plan. That's what halon is trying to accomplish with his cobra brackets. I just need the brackets!!! I found some calipers pretty cheap, soooo just need cheap brackets :)

[s1ngletracker]

dude, you dont even have a running car. Why you spending money on brakes? :P

[Constant_Project21]

It's planning Paul, I haven't bought anything, I'm just researching for when I get to fixing. Figure since it's not moving, I might as well go through everything this time, and make sure the maintenence is all done. I know I need front brakes, so why not make um better while I'm at it.

Have quite a few plans for it before I toss a motor in it, cause if I can't drive it, then I won't be tempted to cut corners like I have on my other dsm's...haha.

[Halon]

I fired up the heater in the garage. I'll be taking them off today. I wrote them a message in their vendor forum, but no one ever said anything back???

[Constant_Project21]

I did as well, those primo guys are sometimes too cool respond ;) (jk'ing guys). Sometimes it takes a couple reminders.