MAPerformance FDSM Progress Pics

[Kevin 1G Drummer]

I dunno if it's just the camera angle or what, but it doesn't look like there's much clearance between those cage bars and the rear tires. Is there enough room there for suspension travel and tire stretch?

[123abc]

That's looking pretty sick guys. Good luck this year.

[FattyBoomBatty]

Good question on the cage interfering with the tires.

[niterydr]

Looking good guys, nice progress made since I was there last!

[v8klla]

Must be the camera angle as the tires aren't that close to the cage, but I see where it looks that way lol. Also, the block has not been hardblocked ;) And yes we have made a few changes to the setup in hopes of adding a little more power...

http://www.maperformance.com/gallery/pictures/magnus.jpg

http://www.maperformance.com/gallery/pictures/magnus2.jpg

[Halon]

I thought you had said the Magnus was going to be cast. Looks purdy though!

Good luck with it all! If it was hardblocked, wouldn't that really kill it's streetability?

[v8klla]

Billet ;) Everything from the plenum base down is one solid piece of aluminum...

[v8klla]

The guys at Meanstreet Performance came through for us once again with the sheet metal work shown below, they even surprised us with a custom touch of RX7! Be sure to check them out here (http://user1358701.sites.myregisteredsite.com/) for all of your roll cage and chassis fabrication needs!

http://www.maperformance.com/gallery/pictures/meanstreet.jpg

http://www.maperformance.com/gallery/pictures/meanstreet2.jpg

[Constant_Project21]

That's some amazing sheet metal work, wow. That magnus intake is goregous as well.

[scheides]

Wow, that looks freaking nice. Maybe I should do that to my evo? :D