PDA

View Full Version : Magnus Motorsports

Pages : 1 2 3 4 [5]
mlomker
02-07-2010, 03:01 PM
someone should make a Carbon Fiber intake manifold, that would be tight.


Wow, I like.
goodhart
02-07-2010, 09:29 PM
If the plenum were a completely round tube, the stresses would be distributed evenly.

You mean like this?

http://i58.photobucket.com/albums/g278/mikegoodhart/CIMG0188.jpg


:D Pushit2.0 SMIM FTW!
1ViciousGSX
02-07-2010, 09:32 PM
You mean like this?

http://i58.photobucket.com/albums/g278/mikegoodhart/CIMG0188.jpg


:D Pushit2.0 SMIM FTW!
Yep, like that.
Halon
02-07-2010, 09:59 PM
You mean like this?

http://i58.photobucket.com/albums/g278/mikegoodhart/CIMG0188.jpg


:D Pushit2.0 SMIM FTW!

Just an observation, but that head flange looks really thin.
goodhart
02-07-2010, 10:58 PM
Just an observation, but that head flange looks really thin.

1/2" thick
tpunx99GSX
02-07-2010, 11:04 PM
I was told a while ago that if its not tapered at the back it causes excess turbulance. because the air hits a wall at the back, also has to do with the velocity of the air, hence why the magnus is such a good one, because it starts off fat, then tapers down. I could be wrong but this is just what i heard from someone who shall not be named.
Kracka
02-08-2010, 06:08 AM
The Pushit1.0 destroyed the Magnus in the last SMIM shootout; higher flow and better runner balance.
Halon
02-08-2010, 07:54 AM
1/2" thick

Probably just the camera angle playing tricks on my eyes then.
goodhart
02-08-2010, 08:15 AM
The Pushit1.0 destroyed the Magnus in the last SMIM shootout; higher flow and better runner balance.

The manifold in the pics is the same one that was used for testing in that too.