CV question

[ESchwanz]

I need to replace the passengers CV, as its clunking a little... I Replaced the tie rod ends this weekend, but it still clunks a little on the right side. Might be a dumb question .. but, do I need a special CV joint due to the 6 Bolt swap in a 2GB.

[Kracka]

Get the correct shaft for your car/transmission; the engine doesn't matter.

[asshanson]

Yea you're transmission is still a 2g, that's all that matters. Might be a good time to get new fluid if you haven't done it in awhile, since you'll have to drain it anyway.

[ESchwanz]

Yea you're transmission is still a 2g, that's all that matters. Might be a good time to get new fluid if you haven't done it in awhile, since you'll have to drain it anyway.

Ahh okay now I understand.... I wasn't thinking about it clearly.. Just had redline not that long ago when MAP put my new clutch in, but new fulid anyhow... if i gotta drain it. thanks for the advice.

[Kevin 1G Drummer]

You shouldn't have to drain it. Just be quick when you pop the old axle out, and put the new axle in. It will drain a little bit out, but if you're quick enough you won't lose enough to make a difference.

[ESchwanz]

You shouldn't have to drain it. Just be quick when you pop the old axle out, and put the new axle in. It will drain a little bit out, but if you're quick enough you won't lose enough to make a difference.

Cool! Good to know! Will be my next purchase then.. right after I go on ECM tuning to order my LINK!!!!! Woot Woot I'm gonna do it... Now I just need to learn how to use it. :)

[asshanson]

Haha, I didn't even think about doing that. I guess if you're really quick you might just lose an ounce or two.

[Kevin 1G Drummer]

I had to change out my front passenger axle last summer, and I only lost a couple teaspoons.