Will my 7 bolt hold?

[GsXtUrBo98]

I have enough mods to hit 300-350awhp and I was told it will blow up... I have arp's and all that stuff to support it. What do you guys think??

I'm planning on running 20psi on a scm6152e

[Dundars]

Yes.

Edit - What dyno do you plan on making those numbers on? Good luck hitting 350awhp on a Dyno Dynamics at that boost level on a 2.0.

[GsXtUrBo98]

My goal is 300 so I wont be dissapointed if I dont make 350...

I have my upgrades on here as my spring upgrades and that has all the stuff I am running on it...

[goodhart]

Yes.

Edit - What dyno do you plan on making those numbers on? Good luck hitting 350awhp on a Dyno Dynamics at that boost level on a 2.0.


It shouldn't be that tough depending on the mods it should be damn close, especially on E-85.

E-85 setups like this are making between 450 and 500 with big enough injectors on Dyno Dynamics.

You won't blow your motor either, there's guys making more power than this on 7 bolts just fine.

[goodhart]

.

[Dundars]

Stock 2g rods still I'm assuming?

If yes, that and crankwalk will be your only weaknesses, but I highly doubt you will run into crankwalk or a bent rod at that power level.

[GsXtUrBo98]

Its a jaster long block with 40k on it and the balance shaft eliminated... as far as I know its all stock internals because the guy before me put it in....

[JET]

It is Jasper, and no you shouldn't have any issues at that point.

[95tsi]

I'd think you should be fine. Shane tuned my car to 358awhp on a stock bottom end with arp's and cams using a 16g.

[GsXtUrBo98]

sounds good