PDA

View Full Version : MitsuStyle Spring 2009 Dyno Day!

Pages : 1 2 3 4 5 6 7 8 [9] 10 11 12 13 14 15 16 17 18 19 20 21 22 23
1QUICK4
04-05-2009, 11:49 AM
So who all is dynoing thier bikes :D
craig
04-05-2009, 03:15 PM
Just street tune the Fiero the best you can, then throw it on the rollers!

yeah thought about that but feel like the clutch isn't holding once it get up and goes right now so we will see. could be the tires letting go too.
4g63tcrazy
04-05-2009, 03:21 PM
For some reason I thought it said the 2nd.. So now I can't go.. :(
A//// Guy
04-05-2009, 04:28 PM
So who all is dynoing thier bikes :D

I plan on it! Unless I get the audi chipped by then.
goodhart
04-05-2009, 10:38 PM
Unfortunately, I may not be able to bring my DSM, we put in the new transmission this weekend and it will only shift into 1st and 2nd, I am in the process of figuring out the problem right now as this was a fully funtional working tansmission before it was in my car. I will for sure be bringing the WRX down though!
Kevin 1G Drummer
04-05-2009, 11:28 PM
So who all is dynoing thier bikes :D
I'll probably bring mine.
turbotalon1g
04-05-2009, 11:45 PM
Goodhart mess with the cable adjustment under the shifter, I was in the same boat until i messed with it, quite simple actually and it was the first tranny out of 4 that needed changing.
goodhart
04-06-2009, 07:11 AM
Goodhart mess with the cable adjustment under the shifter, I was in the same boat until i messed with it, quite simple actually and it was the first tranny out of 4 that needed changing.

We (Myself and 95tsi) messed with the under the shifter linkage, we were able to get more side-to-side play and found fifth, but still couldn't get reverse. We tried two different reverse safety switches, and messed with the under hood linkage, but still no reverse. When we finally pushed it back into the garage, we heard some not so good noises, I'm hoping the transfer case isn't junk.

If I have much more trouble with it, I'll just start a different thread.
Kracka
04-06-2009, 11:27 AM
Is a large intake pipe in the way of the shifter levers on the transmission? I had this happen with one once and the car wouldn't go into reverse until I "clearanced" the intake pipe.
scheides
04-06-2009, 11:30 AM
Ya, or the lower radiator pipe....I had trouble with that on my 2G.