Alot of 1g Parts

[Batmobile2417]

I am pulling everything off of my setup so I can go bigger!
What I have... The price is to shoot me a reasonable offer!
Evo8 fuel pump
Evo8 injectors
1g head with less than 1000 on rebuild
jdm fmic with piping and bov ( This is small but it works)
2g ehaust manifold
small 16g with little shaft play
2 stock intakes
2 valve covers
a set of gauges( volt, water temp, air to fuel ratio not a wideband, boost, oil pressure)
light wieght crankshaft pulley
Contact me at 651-468-1647
Kevin

[Batmobile2417]

also everything you need to run ds-map version 2 or purchase version 3

[Kracka]

Great seller; very honest and nice!

[Batmobile2417]

Great seller; very honest and nice!
Thank You Kracka! And good luck on those Injectors let me know how that goes I would be interested to see how that works out. Nice Car!

[Batmobile2417]

I decided I am also going to sell a stock 4g63 block and a stock manual tranny. I would like 350$ for the block with about 80,000 miles on it. I was looking to get 300$ for the tranny. Engine runs good and trans doesn't grind and shifts smooth.

[T is for TURBO]

Pics of the crank pulley

[At-Least-It's-An-Evo]

I decided I am also going to sell a stock 4g63 block and a stock manual tranny. I would like 350$ for the block with about 80,000 miles on it. I was looking to get 300$ for the tranny. Engine runs good and trans doesn't grind and shifts smooth.

what condition is the short block in? or is it the long block?

[Batmobile2417]

Pics of the crank pulley
sorry I dont have a camera at the moment. It just looks like an aluminum crank shaft pulley

[Batmobile2417]

what condition is the short block in? or is it the long block?
Well it depends on what you want. I bought the short block for 350$ I bought a head for 150$. I barely put any miles on it so if I were to sell every thing together I would hope not to loose money on the deal. It is in good condition. However if I were to pull it I would go through things while it was out (just gaskets and inspection and cleaning) other whise it runs great and I also have some king bearing left over for it as well.

[Batmobile2417]

also have 2 heads that just need some intake valves. The one is in really good condition with less tha a thousand on a rebuild the other one looks ok but not great.