EVo 3 tranny in 1g awd. What youpants pulled know?

[turbotalon1g]

So what do you know that is helpful about doing this?

I have one, and I need to get some information straight so that I don't have my pants pulled down on a price to have it checked out.

I have heard that I just need to change the ring gear and I will be fine to that I need to change intermediate shaft, ring gear and a bunch of other shit i don't know.

THanks

Aaron

[turbotalon1g]

I was told this by someone that offered to do work on the trans for me.

"there is more to do than just the ring gear. I would need you to either ship me your spare transmission for the parts, or I will need you to completely disassemble your other transmission and pull the front differential, the center differential, the output shaft, the output shaft pinion gear and its tapered roller bearings and bearing races and shims, along with your speed sensor, and a couple other little parts. You NEED to swap the output shaft pinion gear and its tapered roller bearings and races, and the front differential ring gear at the MINIMUM!"

[Pushit2.0]

http://www.jackstransmissions.com/dsm_close_ratio_transmission.php?osCsid=4ed6ec0c1a 8d7a09f83893721b961a60

After reading this I know why I "needed" a different welded CD then the one I provided, so I was out a perfectly good welded CD, thanks shep....

[turbotalon1g]

Thanks man.
i don't know what my title is supposed to say in the second half.

Isn't there anyone else that knows anything on this? lol.

[munchgsx]

Does the Evo3 rear diff bolt in to a DSM? That would fix everything.

[munchgsx]

Then again you don't have the T-case either. Do the ratios in the t-cse change at all?

[brando]

you might need a early 2g t-case

[turbotalon1g]

^no.

[Pushit2.0]

If you wanted the tree dodging gears then you would want the Evo rear diff. But putting the evo 3 gear set into the DSM case with the DSM final drive ratios for drag racing.

~John

[turbotalon1g]

I just want a tranny that will hold mediocre power.