PP and disk...slightly used or just too old? (pics included)

[MustGoFaster]

I thought the 2G trans was a bolt in for a 1G except the mounting hole for the starter needing to be drilled out in the backing plate. I thought there was a VFAQ on it but it doesn't seem to be there anymore.

[JET]

I am pretty sure the front mount is in the wrong spot, isn't it? I know a 2g has more room for the compressor outlet where the 1g has the motor mount very close to it.

[asshanson]

I would think you could, because the 2g has front/rear mounts on the transmission, they just wouldn't be used in a 1g application since they're on the block. Then just figure out the passenger side one as John said, and the slightly different different starter place mounting holes as Ryan said.