J-Pipe Suggestions

[mdost03]

Here is my next snag in my engine buildup, does anyone have any suggestions or know of a different J-pipe I could buy that can better position the pipe with my existing piping I made. I am ok with modifying my setup, but figured there was something out there that can better fit up since this piping fit up perfect with my old 50 trim I had on the car.

http://i34.tinypic.com/2di3989.jpg

http://i33.tinypic.com/eam8td.jpg

http://i35.tinypic.com/15do3q.jpg

[Kracka]

How about a flex bump-hose coupler so you can just move the LICP over a bit?

[TkrPerformance]

cut the jpipe shorter and use a humped coupler

[Pushit2.0]

I could cut/weld the Jpipe to move it over the ~1.5" or so it lines up with your LICP.

[Febo]

put it on the floor and stomp that honkey

[Pushit2.0]

Not so much on the that...
That is the first aluminum Jpipe I have seen.