View Full Version : Feeler: Alternator Heat Shield
green hornet
09-05-2008, 11:35 AM
personaly i think it's also a little fugly, clutters up the front of the engin more.
tpunx99GSX
09-09-2008, 12:54 PM
People with external wgs may have a hard time using that. I know Both me and Project2gs dump tubes go right where that would sit.
I think its a good idea, but you would neeed to make it much less boxy. Use a bender to basically make it bend with the alternator. The other thing would be the fact that its metal and sitting really close to the positive of the alternator, you would need some kind of rubber to make sure it doesnt ground out.
1QUICK4
09-09-2008, 02:06 PM
The other thing would be the fact that its metal and sitting really close to the positive of the alternator, you would need some kind of rubber to make sure it doesnt ground out.
There is already a rubber boot on the alternator eyelet from the factory.
Looks good man, If I wasn't relocating mine I'd snap one up.
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.