WTB: CLUTCH ASAP by this weekend

[EclipseGST]

with the fidanza fly wheel i have the clutch hub dosent sit flush with the tabs on the fly wheel is that ok,

You need to torque it down... Use a torque pattern like a star, (like putting a wheel on a car) to make sure it gets torqued evenly and you dont warp the clutch, tightening each bolt 1/2 a turn or so until the clutch sits flush with the flywheel. Make sure the bolts are torqued to spec.

[JET]

Also, make sure you don't tighten it down until the clutch is on the car or you won't be able to get the splines aligned on the disk.

[EclipseGST]

Good point, also make sure the clutch disk is installed the correct way otherwise you will snap it.

[green hornet]

yea thats what i figured, i was just tripin out a little cause i have so much to do befor i put the motor in on friday, oh well thanks for straightining every thing out guys.