Laptop Wont Connect To AEM!!!!

[blageo23]

"failure connecting to ECU"

[TheBlizzard]

If you change the cable and that doesn't fix it then I would think the serial port on either the AEM or your laptop is fried. There really isn't a whole lot to connecting. Have you made sure there are no broken wires/connectors?

[blageo23]

OK, downloaded the program on my other laptop and it connected. Im going to try and redownload the program(cuz like I said i have been having troubles with it) and see if that works.

[Goat Blower]

I just had this earlier this week. Thing is it also didn't kick the fuel pump on. I swapped the AEM with Mo's and then put it in and it worked fine. I'm 99% sure it was the ignition switch in my case. But if your fuel pump kicks on, it's gotta be the connection. Try someone else's laptop with AEMPro installed.

[blageo23]

I did and it worked on the other laptop I have. BUT the computer that works the battery BLOWS(10 min max). So is it just my computer or is there a way that the connection(serial port) can be "turned off" on a computer?

[FattyBoomBatty]

Yes, there is. Right click on my computer, then on hardware, then click device manager.

Go maybe 3/4 down the list and find "Ports". click that once, if there are any error signs you can see that quickly.

You should have "communications port 1" or something. Right click that, go to properties. You can turn on the port from there and change some settings.

[blageo23]

hmm, Its turned on and there doesnt seem to say there is a problem.

[blageo23]

went to go try and start the car again and the fuel pump does not run and the gauges dont light up anymore. I tried to connect to it with the computer and I get this...
Online
Parity Error
Framing Error
Offline
Online
Parity Error...

It continues like that. Anyone know anything about this?

[blageo23]

New problem, anyone?

[blageo23]

OK this is fucked up! It still wouldnt start but my gauges were dim lit except the serial gauge. I went to plug the serial gauge into the AEM and then I turned the key to on and everything work. If I unhook the gauge nothing works. WTF!