Another weekend project...

[95talonracer]

I got it all finished and everything works but when I go to start the car, the fuel pump kicks on and all but the starter will not go like you are not even trying to start the car. any ideas at all? all plugs are in as well, what can cause no turnover even when the starter is getting power?

[blageo23]

Make sure the CAS is wired correctly. also make sure that you plugged the starter in. I had wired the CAS wrong one time and the power cable for the starter came out of the ring terminal one time.

[blageo23]

PS: I HATE YOU!(JK just really jelous)

[95talonracer]

Anyone have any ideas on this problem? My car has power, the starter gets power, the fuel pump turns on when the key is in the starting position but doesnt click on when turned on at first. The fuel pump also doesnt click on when you take off the cas sensor cap and plug it back in. It is a 97 gst spyder with a 6 bolt swap. no burnt out fuses, I have no idea. Anyone have this problem?

[95talonracer]

Anyone???

[FattyBoomBatty]

The starter solenoid? if it doesn't even click then you probably don't have the solenoid hooked up.

[95talonracer]

The starter solenoid? if it doesn't even click then you probably don't have the solenoid hooked up.

It is hooked up. Its something else. is there anything that controls both the cas and the starting besides the ecu? I jumped the solenoid and the starter is good and spins.

[blageo23]

Try tossin in the stock ECU. And remember when you put the 95 ecu in you have to swap the 1 and 4 wires with the 2 and 3 wires. But that doesnt help with the no start. Otherwise double check you hookup the CAS up right. I was sure I did but it was wrong the first time.

[rst95eclipse]

Check your wiring.

[FattyBoomBatty]

Check your wiring.

Solid Advice. lol.